Skip to content
Open access

IoT-Based 100 WP Solar Power Plant for Ultraviolet Lighting in Dragon Fruit Cultivation: Design and Performance Comparison of Tracking and Non-Tracking Systems

Aug 2026 · International Journal of Current Science Research and Review · 0 citations

TL;DR

The results demonstrate that combining solar tracking with IoT monitoring can improve the observed electrical performance and facilitate remote management of a small off-grid photovoltaic lighting system.

Abstract

The use of solar energy for agricultural applications can reduce dependence on conventional electricity while enabling operation in locations where grid access is limited. This study aimed to design and evaluate a 100 Wp photovoltaic system integrated with an Internet of Things (IoT) monitoring and control system for lighting in a dragon fruit plantation. The system employed a 100 Wp monocrystalline solar panel, a solar charge controller, a battery storage unit, an inverter, an ESP32 microcontroller, voltage and current sensing, and Telegram as the remote monitoring interface. Electrical parameters were observed hourly from 09:00 to 17:00 WIB under two panel configurations: solar tracking and fixed non-tracking. Panel voltage, panel current, battery voltage, and calculated panel power were analyzed. For the tracking configuration, the average panel voltage and current were 19.64 V and 4.12 A, respectively, corresponding to an average calculated power of 81.47 W. The maximum calculated power was 100.94 W at 12:00. Under the non-tracking configuration, the average voltage and current were 18.69 V and 3.61 A, with an average calculated power of 68.08 W and a maximum of 91.65 W at 12:00. Thus, the tracking configuration produced approximately 19.7% higher average calculated panel power than the non-tracking configuration. The ESP32–Telegram system successfully transmitted operating information in real time when a stable Internet connection was available. The results demonstrate that combining solar tracking with IoT monitoring can improve the observed electrical performance and facilitate remote management of a small off-grid photovoltaic lighting system.

Read PDF

Similar papers

Open access Aug 2026

Design of an IoT-Based Electrical System for an Unmanned Solar-Powered Car Prototype

The increasing development of renewable energy technologies has encouraged the integration of photovoltaic (PV) systems into small-scale electric vehicle platforms. This study aims to design and evaluate an Internet of Things (IoT)-based electrical system for an unmanned solar-powered car prototype using a 3 Wp monocry...

Bambang Anggoro Putro, Sri Poernomo Sari · 0 citations
Open access Sep 2026

Design and Energy-Balance Assessment of Adaptive Power Management for a Solar-Powered IoT Smart Buoy

Autonomous marine Internet-of-Things (IoT) platforms must preserve sensing and telemetry functions under a limited and weather-dependent energy supply. This paper develops an energy-aware power-management assessment for a multi-parameter smart buoy using only the implemented design parameters and field records of the p...

Dimas Aditya Wiranata, Anton Widodo · 0 citations
Open access Oct 2026

Temperature impact analysis on photovoltaic output power using an IoT-based wiper cooling system

Solar photovoltaic (PV) performance is significantly affected by surface temperature and panel cleanliness, both of which influence energy conversion efficiency. Elevated temperatures reduce power output, while dust accumulation decreases effective solar irradiance. This study proposes an IoT-based integrated cooling a...

A. B. Kusumaningtyas, I. Kamil, Adnan Afriadi · 0 citations
Open access Sep 2026

Two-Stage Maximum Power Point Tracking Photovoltaic Converter for IoT Sensor Nodes with Hardware Validation

Continuous operation is increasingly expected of Internet of Things (IoT) and wireless sensor network (WSN) nodes, yet practical solar front ends must account for source variability, intermediate storage, conversion losses, sensing overhead, and battery-management constraints. This article develops and evaluates a disc...

Q. Awais, Muhammad Hammas, H. Ahmed et al. · 0 citations
Open access Aug 2026

a Design of an IoT-Based Control and Monitoring System for a Biogas Power Generation Plant Using POME Waste from Palm Oil Mills

Palm Oil Mill Effluent (POME) contains a high organic load that can be converted into biogas through anaerobic digestion and subsequently utilized for electricity generation. However, maintaining stable digester conditions requires an integrated monitoring and control system capable of observing critical operating para...

A. Asminar, Rifki Rifki, Akhyar Muchtar et al. · 0 citations

We use cookies to run the site and, with your consent, for analytics and to show ads. See our Cookie Policy.