Skip to content

Nonlinear dynamic modeling and ride performance analysis of a mode-switching hydro-pneumatic suspension for mining dump trucks

Sep 2026 · Proceedings of the Institution of mechanical engineers. Part D, journal of automobile engineering · 0 citations · 19 references

Abstract

Heavy mining dump trucks are subjected to severe road excitation and large payload variations, which make it difficult for conventional passive hydro-pneumatic suspensions to achieve satisfactory ride performance. To address this issue, this study proposes a mode-switching hydro-pneumatic suspension with four discrete stiffness-damping modes realized by the coordinated switching of two accumulators and two throttling branches. A nonlinear dynamic model of the suspension is established by considering gas compression, chamber pressure variation, throttling flow, check-valve switching, and friction. To evaluate the mode-dependent vertical ride performance, the suspension model is integrated with an effective road-input model considering tire enveloping and a two-degree-of-freedom quarter-car model in an AMESim-MATLAB/Simulink co-simulation framework. Static and dynamic bench tests are carried out to validate the model. The results show that the proposed suspension exhibits clear nonlinear and mode-dependent dynamic characteristics, enabling staged adjustment of equivalent stiffness and damping. The quarter-car-based simulations indicate that the influence of suspension mode is more significant under full-load conditions. Under severe road excitation, the soft-stiffness/high-damping mode provides the best vibration-isolation performance. The experimental results agree well with the predicted overall trends, confirming the validity of the proposed model. This study provides a practical suspension concept and a validated modeling framework for ride-oriented design of hydro-pneumatic suspensions for heavy-duty mining vehicles.

View source

Similar papers

Oct 2026

Dynamic performance and pneumatic power characteristics of automotive air suspension systems: Integrated modeling and experimental validation

Air suspension systems exhibit strongly nonlinear behavior due to air compressibility, thermodynamic effects, and pneumatic flow restrictions. This study develops and experimentally validates an integrated analytical model of an air suspension system. The model integrates air-spring thermodynamics, compressible solenoi...

J. Lee, Jeongwoo Lee · 0 citations
Oct 2026

Analysis of roll angle dynamic behavior in heavy dump trucks during lifting process based on MBD-DEM coupling

This paper proposes a dynamic modeling method for heavy dump trucks during lifting operations on sloped terrains. Traditional linear models are limited in capturing system nonlinearities and external disturbances, which are addressed in the proposed approach. Both the rear-dump truck and the side-dump truck are selecte...

Yu-Yang Chen, Ming-Mao Hu, Yong-Chao Li et al. · 0 citations
Open access Oct 2026

Nonlinear Dynamic Modeling and Parametric Analysis of Oleo-Pneumatic Shock Absorbers with Contact-Separation Dynamics for Aircraft Landing on Uneven Runways

The dynamic response of aircraft during landing on uneven runways is critical to structural integrity and passenger safety, especially under conditions involving impact, nonlinear energy dissipation, and intermittent contact. Existing models commonly assume continuous tire-runway contact, limiting their ability to capt...

Farzad Fallahi, S. Kędziora · 0 citations
Open access Nov 2026

Nonlinear Shock Absorber Dynamic Analysis of Vehicle Suspension System Using Performance Indices

Abstract In this study, the behaviors of nonlinear shock absorber for both rebound and compression configurations are investigated for use on vehicles under a rounded road disturbance. The dynamic behavior of automotive suspension system is analyzed using a quarter-car model taking into account the nonlinearity of comp...

S. Khalfallah, Nahla Soualem · 0 citations
Oct 2026

Hierarchical creep control and a dynamic-response-oriented parameter tuning method for multi-axle distributed electric vehicles

Vehicle creep control is widely used for vehicle following in congested traffic and maneuvering in confined areas, and it can greatly ease the burden of driving in these situations, especially for heavy vehicles. In this paper, a hierarchical creep control strategy is proposed for multi-axle distributed electric vehicl...

Xiao-Han Li, Jun-Qiu Li, Zi-Zheng Liu et al. · 0 citations

We use cookies to run the site and, with your consent, for analytics and to show ads. See our Cookie Policy.