Transient Evolution of the Piston–Cylinder Oil Film and Thermo–Fluid–Solid Coupling Response in an Axial Piston Pump Under Complex Operating Conditions

Abstract

Existing piston–cylinder lubrication studies often simplify the pressure boundary as a constant load or a single field, making it difficult to capture pump-level pressure excitation, local oil-film response, and non-concentric posture under variable loading. This paper establishes a thermo–fluid–solid coupling framework integrating an AMESim full-pump model, a Fluent transient oil-film model, and a Transient Structural model; UDF transfer of periodic pressure, dynamic meshes, and a calibrated Roelands law were used to analyze parallel-offset and center-tilted postures. As the load pressure increased from 10 to 30 MPa, the maximum discharge–half-cycle temperature rose from 28.39 to 36.95 °C, and the average positive leakage during the third-cycle high-pressure stage increased from 0.0201 to 0.1026 L/min; increasing speed from 1000 to 3000 r/min reduced cycle-averaged leakage by 8.93%. At 500 r/min and 30 MPa, the parallel-offset case reached 46.34 °C, 41 kPa, and 0.0990 L/min in maximum temperature, maximum shear stress, and average leakage, whereas the center-tilted case produced a peak resultant force of 3537.12 N, a cylinder inner-wall high-stress band of 76.96 MPa, and a maximum piston deformation and equivalent stress of 4.31 μm and 83.16 MPa. These results clarify the distinct lubrication behavior and potential uneven-wear risk associated with the two representative non-concentric postures, and provide a basis for clearance design and posture-sensitive condition assessment of axial piston pumps.