Skip to content
Open access

Hot Deformation Behavior and Processing Map Analysis of As‐Cast Fe–Cr–Ni–Al–Ti Low‐Magnetic Stainless Steel

Sep 2026 · Steel Research International · 0 citations · 61 references

Abstract

A precipitation‐strengthened Fe–Cr–Ni–Al–Ti low‐magnetic stainless steel (15A4‐A15) was designed to improve yield strength while maintaining excellent plasticity. The complex alloying composition results in pronounced dendritic segregation and interdendritic NiAl/Ti‐rich Laves phases, increasing the risk of cracking during hot working. Hot compression tests were conducted at 900–1050 °C and strain rates of 0.01–10 s −1 . The flow stress decreased with increasing temperature or decreasing strain rate, reflecting enhanced dynamic softening. A strain‐compensated constitutive model showed good predictive accuracy ( R 2  = 0.9653, AARE = 4.526%). The apparent activation energy of 437.19 kJ/mol indicates that hot deformation is governed by multiple thermally activated mechanisms rather than lattice diffusion alone. EBSD analyses revealed that hot workability is jointly controlled by dynamic recrystallization and the evolution of the heterogeneous as‐cast microstructure. Stable processing conditions promote homogeneous recrystallization and reduced stored deformation energy, whereas unstable conditions intensify strain localization and microstructural heterogeneity. Processing maps identified two favorable hot‐working windows, 900–1050 °C/0.01−0.04 s −1 and 1000–1050 °C/3–10 s −1 . Representative hot‐rolling experiments performed under typical stable and unstable conditions exhibited markedly different deformation behaviors consistent with the processing map predictions, confirming the reliability of the proposed processing map for optimizing the hot‐working parameters of as‐cast Fe–Cr–Ni–Al–Ti low‐magnetic stainless steel.

Read PDF

Similar papers

Open access Oct 2026

Hot Deformation Behavior and Microstructural Evolution of a 5Mn Medium‐Mn Steel: Strain‐Compensated Arrhenius Modeling and DMM Processing Maps

Isothermal hot‐compression tests (850–1150 °C, 0.1–10 s −1 ) were performed on a 5Mn medium‐Mn steel to elucidate its high‐temperature flow behavior and microstructural evolution. Flow stress decreases with increasing temperature and increases with strain rate. Dynamic recovery (DRV) dominates at high‐strain‐rates,...

Kai-Wen Zhang, Zi-Hang Qu, Tian-Kun Peng et al. · 0 citations
Open access Sep 2026

Strain‐Induced NbC Precipitation as a Governing Mechanism for Hot Deformation Resistance in CrNiMnMoB Ultrahigh‐Strength Steels

Two low‐C CrNiMnMoB ultrahigh‐strength steels, one Nb‐free (0Nb) and one microalloyed with 0.04 wt.% Nb (4Nb), were developed to investigate the role of Nb in hot deformation behaviour, strain‐induced precipitation, and microstructural evolution. Isothermal single‐hit compression tests were conducted over 850–1250 °C...

A. Hamada, A. Khosravifard, Khaled Elanany et al. · 0 citations

We use cookies to run the site and, with your consent, for analytics and to show ads. See our Cookie Policy.