Skip to content

Integration of Computer Vision and CNC Machining for Automated Object Measurement and Customized Packaging

2026 · Journal of Image and Graphics · 0 citations · 28 references

Abstract

— This paper presents an integrated computer vision — Computer Numerical Control (CNC) workflow that measures an object ’ s planar footprint and automatically generates G-code to cut customized cardboard packaging, thereby reducing manual sizing and setup in low-cost manufacturing environments. Specifically, a monocular camera within a controlled enclosure captures a single image, after which contour extraction, centroid estimation, and pixel-to-millimeter calibration are applied to convert pixel distances into metric length and height estimates; these measurements are then translated into CNC laser toolpaths and validated in Laser G-code Real-Time Blink Loop (LaserGRBL) prior to cutting. The approach was evaluated on 59 heterogeneous objects against calliper/ruler measurements, yielding sub-millimetric performance (Mean Absolute Error (MAE): 0.793 mm in length and 0.861 mm in height; RMSE: 1.057 mm and 1.394 mm, respectively). Moreover, most items exhibited errors below 2%, confirming suitability for practical packaging tolerances; nevertheless, occasional outliers (e.g., a 7.49% height error for a small snap-fastener case) indicate that further gains may be achieved through improved illumination control and enhanced contour robustness. Overall, these findings evidence a scalable route to on-demand packaging automation that effectively bridges perception and fabrication for small enterprises.

View source

We use cookies to run the site and, with your consent, for analytics and to show ads. See our Cookie Policy.