Skip to content
Open access

Time-Delay Estimation for Partial Discharge in Arresters Using Joint Denoising and HB-Weighted Cross-Correlation

Sep 2026 · Energies · Vol 19, pp. 4276 · 0 citations · 32 references

Abstract

Partial discharge (PD) detection is a crucial means for the early warning of incipient insulation defects in arresters. However, under strong electromagnetic interference and background noise, PD signals are prone to distortion, making it difficult to accurately determine the pulse onset front and thus severely degrading the accuracy of time-delay estimation. To address the difficulty of time-delay estimation under low signal-to-noise ratio (SNR) and multi-channel aliasing conditions, this paper proposes a method for arrester PD detection and high-precision time-delay estimation based on joint denoising and improved cross-correlation. First, a joint denoising strategy that integrates singular value decomposition (SVD), variational mode decomposition adaptively optimized by the sparrow search algorithm (SSA-VMD), and the Teager energy operator (TEO) is constructed. This strategy suppresses white noise and periodic narrowband interference while effectively extracting the oscillatory onset characteristics of PD pulses. Second, an enhanced time-delay estimation method based on HB-weighted generalized quadratic cross-correlation is introduced. By employing the dual mechanisms of HB frequency-domain weighting and amplitude weighting to sharpen the correlation peak, the estimation robustness under low SNR is improved. Simulation results show that the proposed method attains an accuracy of 99.9911%, significantly outperforming conventional cross-correlation, PHAT-SCOT, and NLMS methods. Finally, experiments are conducted on a needle-plate discharge platform. In multiple comparative experiments with different spatial distance differences (ranging from <30 cm to >50 cm), the maximum relative error is kept within 0.6%, verifying the reliability and accuracy of the proposed algorithm under controlled laboratory conditions. This method can provide a new approach for online monitoring and accurate fault location of arresters in power systems.

Read PDF

Similar papers

Open access Oct 2026

Parameter-Adaptive VMD and Secondary Wavelet Filtering for Cable Partial Discharge Denoising

Among the various online monitoring methods for assessing the insulation condition of high-voltage cables, partial discharge (PD) detection is among the most widely applied. However, PD signals acquired in field environments are highly susceptible to noise interference. To address this issue, this paper proposes a nove...

Ke Shang, Jian-Wei Song, Yi-Kang He et al. · 0 citations
Conference Open access Sep 2026

Research on Data-Driven Signal Processing Methods for Wind Turbine Circuit Breakers

The opening and closing characteristic curves of wind turbine circuit breakers are susceptible to electromagnetic interference and sensor noise during field measurement, while fault samples are extremely scarce in actual operation, posing significant challenges for data-driven fault diagnosis modeling. To address these...

Xiao-Feng Wang, Duan-Jiao Li, Cong-Wei Yao et al. · 0 citations
Open access Sep 2026

A non-contact vibration detection and partial discharge fault diagnosis method for high-voltage switchgear

To address the early concealment of partial discharge (PD) defects in high-voltage switchgear and the difficulty of external non-contact identification, this paper proposes a PD defect identification method based on laser Doppler vibrometry and vibration signal analysis. A KYN28-12 high-voltage switchgear cabinet is ta...

Zhao-Tun Men, Chun-Hua Fang, Rong Xia et al. · 0 citations
Open access Sep 2026

Safety risk point identification and localization in power equipment based on electromagnetic signals and a multiscale attention convolutional neural network

INTRODUCTION: Safety risk points in power equipment often produce weak and non-stationary electromagnetic responses. These responses are difficult to identify when partial discharge, contact anomalies, insulation deterioration, and shielding defects occur under complex operating conditions. OBJECTIVES: To improve risk...

Si-Wu Yu, Fan Song, Xing Liu et al. · 0 citations
Open access Oct 2026

Refined Processing and Quantitative Interpretation of DAS-Monitored Steady-State Injection Profiles

For a long time, improving extraction efficiency while minimizing environmental hazards has been a key concern for petroleum reservoirs worldwide. Distributed acoustic sensing (DAS), being environmentally friendly, offers a new solution for long-term monitoring of production and injection wells. However, in actual logg...

Guang-Yao Chen, Li-Xiong Gan, Cheng-Wen Xiao et al. · 0 citations
Open access Sep 2026

Time-Frequency Feature Extraction and Modal Component Reconstruction for Structural Dynamic Monitoring Using MTM-eNTFT

Field-measured structural responses are often noisy, multicomponent, nonstationary, and finite in length, complicating dominant-frequency identification, component extraction, and time-frequency characterization. This study develops an MTM-assisted Normal Time-Frequency Transform procedure with multiscale permutation e...

Ling'ai Li, Jun-Wei Wang, Chi Zhang · 0 citations

We use cookies to run the site and, with your consent, for analytics and to show ads. See our Cookie Policy.