Investigation on Flexural and Compression Strength and Microstructures of Vacuum Assisted 3D Printed Samples
Abstract
Additive manufacturing (AM) has advanced significantly over the last decade, enabling the creation of complex geometries with functional parts. However, integrating vacuum pressure into open-source Fused Deposition Modeling (FDM) 3D printers remains underexplored, particularly regarding its impact on the flexural and compression strengths of printed samples. This study investigates optimal printing process parameters to enhance these mechanical properties, focusing on infill density (25%, 50%, 75%, and 100%) and vacuum pressure (21 inHg, 24 inHg, 27 inHg, and 30 inHg). Using ABS material, 48 samples were fabricated with an Up Plus 2 FDM printer encapsulated in a vacuum chamber, employing a complete factorial design with three replicates per parameter combination. Samples underwent flexural and compression strength tests, revealing a direct correlation between increased infill density and improved mechanical properties. Vacuum pressure significantly enhanced strengths, achieving up to a 100% increase in flexural strength and a 75% improvement in compression strength. Optimal conditions yielded a flexural stress of 39.76 N/mm² at 30 inHg/100% and a compression stress of 38.69 N/mm² at 27 inHg/100%. Microstructural analysis via optical microscopy confirmed enhanced interlayer bonding in vacuumassisted samples compared to non-assisted ones. These findings underscore the critical role of vacuum pressure in improving the mechanical properties of 3D-printed components, providing valuable insights for advancing FDM technology.