Skip to content
Open access

The Study of Short-Circuit Flow in Gas Cyclones Based on Numerical Simulation

Sep 2026 · Separations · Vol 13, pp. 251 · 0 citations

Abstract

Short-circuit flow severely degrades cyclone separation, yet its influence zone has not been clearly defined. In this work, the Reynolds stress model (RSM) was adopted to perform numerical simulations for a 300 mm PV-type cyclone separator, and the simulation results were validated against published tangential-velocity experimental data. The radial velocity along the extension lines of the vortex finder’s inner wall was analyzed to define the short-circuit flow influence zone, and a sector-resolved intensity index was proposed to quantify its circumferential non-uniformity. The results show that the lower boundary of the influence zone is a circumferentially varying curved surface rather than a horizontal plane. Among the four sectors, the 180–270° sector exhibits the greatest penetration depth (55 mm) and the highest inward radial velocity (−15.45 m/s). The proposed index indicates that Sector III contributes 38.7% of the total short-circuit flow intensity, and the dimensionless index is 0.127 for the present case. Within the influence zone, the inward radial velocity peaks at Z = 12 mm and approaches zero by Z = 53 mm, while the tangential velocity increases from 4.22 to 57.13 m/s, indicating Rankine vortex development. The short-circuit flow is governed by the coupled effects of inlet jet squeezing, vortex-core displacement, and the interaction between upward and downward flows. The proposed influence-zone definition and intensity index provide a quantitative framework for describing short-circuit flow and may be useful for evaluating cyclone design and short-circuit-flow suppression strategies.

Read PDF

Similar papers

Open access Oct 2026

Numerical Study of Flow and Heat Transfer in the Air-Side Channel of Panel-Type Radiator with Novel Vortex Generators

A novel hollow triangular conical-wing vortex generator (HTCVG) was proposed to enhance the heat transfer performance of a panel-type radiator for oil-immersed transformers. A numerical investigation was conducted to compare the HTCVG with a common delta-wing vortex generator (DWVG) and a trapezoidal-wing vortex genera...

Wen-Rong Si, Ying-Ying Zhao, He-Li Ni et al. · 0 citations
Open access Nov 2026

Comparative Study on Experiment and Numerical Simulation of Annular Multiphase Flow

Annular gas–liquid flow is more complex than the flow in circular pipes because the inner and outer walls can support two liquid films. This study addresses the limited quantitative information available for inclined, dual-size annuli by combining controlled air–water experiments with three-dimensional transient comput...

Hong-Tao Jing, Wei Li, Chang'e Kong et al. · 0 citations
Open access Sep 2026

Optimized Hydrodynamic Profiling of a Vortex Chamber Configuration

In modern industrial processes, particularly in the oil and gas, mining, and chemical sectors that handle complex multiphase flows (gas–liquid–solid), enhancing vortex separators is a critical engineering task to ensure the efficient separation of raw materials. The hydrodynamic characteristics and energy losses of suc...

Symeon Yesypchuk, O. Liaposhchenko, J. Piteľ et al. · 0 citations
Nov 2026

A study of supersonic flow past a plate using a two-fluid turbulence model

This paper presents a numerical study of supersonic flow past a sharp flat plate at zero incidence using a two-fluid turbulence model written in von Mises variables and solved with an implicit marching finite-difference scheme. Velocity, skin-friction, temperature, and turbulent Prandtl number distributions were obtain...

Z. Malikov, F. Nazarov, Nilufar Rakhmonova · 0 citations

We use cookies to run the site and, with your consent, for analytics and to show ads. See our Cookie Policy.