Oct 2026· Scientific Reports· Vol 16· 0 citations· 56 references
Abstract
In this article, the details of the development and result analysis of a 9-level SC-MLI have been presented. The proposed system achieves a quadruple voltage gain (4 ×) and generates a 9-level waveform. The proposed system not only achieves a quadruple voltage gain (4 ×) as an advantage but also used minimal component-efficient architecture; it utilizes only three capacitors, diodes, and 9 power switches, thereby minimizing system cost and complexity while enhancing reliability. A Phase Disposition (PD) Pulse Width Modulation (PWM) is implemented for precise switching control. During the discharging and charging of the capacitor spike occurs. To address this inherent challenge, a small inductor was added, which effectively suppresses current inrush and extends component lifespan. A comprehensive comparative analysis was conducted to evaluate the proposed topology's superiority over existing9-level SC-MLIs in terms of component count, voltage gain, and efficiency. Moreover, the closed loop with PV tied to the grid was analysed, and the proposed system ensures MPPT of the solar photovoltaic. To verify the theoretical analysis, experimental verification through a 1.4 kW laboratory prototype, controlled via a dSpace 1103 platform, and simulations done in MATLAB SIMULINK, was conducted. Finally, the proposed efficiency of the proposed topology was exceeding 97%, and the THD of the grid current was below 2% and, confirming the theoretical analysis.
Conventional switched capacitor boost-multilevel inverters have been widely adopted in solar energy systems and electric vehicles, but their performance is constrained by limited voltage gain, increased switch count, and capacitor voltage imbalance. To mitigate these drawbacks, this paper proposes three phase a single...
Y. V. Sambhavi, K. M. Sanjeeva Kumar, Satyajit Das et al.· IEEE Access· 0 citations
This paper presents a self-balanced five-level active neutral-point-clamped inverter with unity voltage gain. The proposed topology consists of seven active switches, six diodes, a low-voltage switched capacitor, and two dc-link capacitors to generate a five-level output voltage without requiring an additional voltage-...
Rezwan Allabasha, K. Vijayakumar, Meshari S. Alshammari et al.· IEEE Access· 0 citations
To address the issues of high component count, complex control, and large volume associated with conventional multilevel inverters in residential photovoltaic (PV) energy storage systems, a novel 11-level voltage-multiplier inverter topology is proposed in this paper. The proposed structure consists of a front-end volt...
Shi Liu, Cheng-Jun Liu, Gao-Yue Guo et al.· 2026 IEEE 9th Information Te...· 0 citations
Transformerless multilevel inverters (MLIs) with voltage-boosting capabilities have become an attractive choice for utility grid-connected photovoltaic (PV) systems due to their compactness, high efficiency, and cost-effectiveness. However, leakage current caused by the absence of galvanic isolation remains a major con...
The deployment of next-generation ultra-high-power tandem photovoltaic (PV) modules demands front-end DC-DC converters capable of processing high input currents while achieving large DC voltage gain. However, conventional high-gain topologies are often constrained by excessive component stresses, elevated device counts...
M. E. El Kattel, Robson Mayer, Kassio Derek Nogueira Cavalcante et al.· IEEE Access· 0 citations
The article introduces an upgraded version of the nine-level (9-L) asymmetrical full bridge submodule (A-SM) based modular multilevel converter (MMC) for high voltage direct current (HVDC) transmission. This enhanced design decreases the quantity of MMC SMs by a quarter in comparison to the conventional MMC, while stil...
H. Chaudhari, Divyesh J. Vaghela, P. Darji· Engineering Research Express· 0 citations
We use cookies to run the site and, with your consent, for analytics and to show ads.
See our Cookie Policy.