Skip to content
Open access

Transmission Line Fault Protection and Detection System Using Current Sensing and an ATmega328P Microcontroller

Oct 2026 · World Wide Journal of Multidisciplinary Research and Development · 0 citations

Abstract

Faults on overhead transmission lines produce very large currents that can damage equipment and interrupt supply, and manual response is too slow to prevent this. This paper presents the design and a laboratory prototype of a low-cost protection and detection system built around an Arduino Uno (ATmega328P). Line current is measured with a current transformer or an ACS712 Hall-effect sensor, conditioned to the 0–5 V range of the analog-to-digital converter, and compared with an overload band and a short-circuit threshold. Overloads cause a delayed trip so that transients can pass, while short circuits cause an instant trip through a relay driver and breaker contacts. A 16×2 LCD shows the line condition and fault type, and a buzzer raises an alarm. In bench tests on a scaled prototype with simulated faults, the system tripped in under 20 ms, achieved 99.4% tripping execution accuracy and fully isolated the protected load. The design is simple, uses commonly available parts and can be extended with GSM alerts, IoT telemetry and impedance-based fault location.

Read PDF

We use cookies to run the site and, with your consent, for analytics and to show ads. See our Cookie Policy.