Skip to content

Backside Laminate Removal of Wafer-Level Packaging (WLP) Devices Mounted on Board

Oct 2026 · International Symposium for Testing and Failure Analysis · Vol 85458, pp. 683-686 · 0 citations

Abstract

In failure analysis, demounting and mounting of IC devices on printed circuit boards (PCBs) are commonly performed for electrical verification and functional testing. Devices with bumps or solder balls, such as Ball Grid Array (BGA) and Wafer-Level Packaging (WLP) devices require reballing during these processes, which involves repeated heat exposure that can induce stress and potential damage. Traditional backside laminate removal methods, including mechanical and chemical techniques, are either time-consuming or risk damaging the die or PCB. This study demonstrates laser ablation as a method for backside laminate removal of WLP devices while remaining mounted on the PCB. Optical and infrared (IR) imaging confirmed complete exposure of the die backside without scratches, chip-out, or PCB damage. Curve trace testing (CT) before and after the process showed no change in electrical characteristics, indicating preserved device functionality. By eliminating repeated demounting, mounting, and reballing, this technique minimizes thermal and mechanical stress, preserving structural and electrical integrity. Laser laminate removal offers a faster, efficient, and safe solution for fault isolation preparation in failure analysis, addressing the limitations of conventional methods while maintaining both device and PCB functionality.

View source

Similar papers

Open access Sep 2026

Research on the Patterning Polyimide Layer Based on Laser Ablation Technology

Polyimide (PI) has emerged as a critical material in advanced semiconductor packaging owing to its high temperature stability, low dielectric constant and loss, mechanical flexibility and stress relief, and chemical and moisture resistance. The passivation (PA) layer is usually formed by polyimide-based lithography tec...

Ji-Kang Liu, Yao Wang · 0 citations
Open access

Thermoforming process analysis for in-mold electronics devices

(English) In-Mold Electronic technology enables the creation of three-dimensional shaped electronic surfaces by combining printed electronics with In-Mold Decoration. This innovative approach enables the integration of electronic circuits into a wide range of complex and diverse applications, going from automotive inte...

F. Arias-García · 0 citations
Review Sep 2026

ENHANCING PROCESS EFFICIENCY AND COST SAVING IN BAG-AND-SEAL PROCESS USING A DMAIC APPROACH: A CASE STUDY IN SEMICONDUCTOR MANUFACTURING FACTORY

The Bag and Seal (BNS) process protects moisture-sensitive substrates before chip attach. In the current method, substrates are moved from liquid crystal polymer (LCP) tray to thermal form tray (TFT) for sealing and then returned to LCP trays, which requires ACL tools and leads to TFT deformation, long cycle time, and...

Phuong NguyenThi, Ngoc Hien Do · 0 citations
Open access Sep 2026

Low-Cost Laser Decapsulation of Wire-Bonded Memory Packages with Dual Thermal Gating for Forensic Data Preservation

Chip-off examination remains the method of last resort in digital forensics, applied when a device is locked, damaged or non-responsive, and it is the only route to data on many embedded targets such as vehicle event recorders and dashcams. The dominant removal technique is thermal reflow at approximately 360°C, and th...

G. Lloyd · 0 citations
Open access Sep 2026

PCB Layout Influence on the Reversibility of Planar Soldered PCB-to-PCB Interconnections

Power electronics converters rely on a wide range of physical implementation architectures. PCB-to-PCB interconnections are widely used to interconnect mother and daughter boards for control, driver, and IPEM implementation, and can take several technological forms such as pins, screws, press-fit or soldering. These in...

Lucas Pinto, Andre G. Andreta, Noe Bourdon et al. · 0 citations

We use cookies to run the site and, with your consent, for analytics and to show ads. See our Cookie Policy.