Comparative Analysis of Substation Configurations for Power Supply of Industrial Process Plants with Non-Linear Electrical Loads
Abstract
Currently, there is an intensive process of introducing power electronics devices into various technological complexes. At the same time, the non-linear and pulsed nature of the processes of electrical energy conversion by means of switching elements leads to the problem of the negative impact of power electronics devices on the quality of electrical energy in the supply network. Often, the introduction of new equipment occurs without due attention to the problem of electromagnetic compatibility (EMC). Issues of mutual influence between previously installed and newly commissioned electrical equipment begin to be addressed only after accidents. The situation is aggravated by the fact that under certain combinations of power supply system parameters and non-linear electrical consumers, an amplification of voltage waveform distortion may occur due to resonance phenomena, which leads to disruption of electrical equipment performance. The problem of ensuring EMC becomes particularly acute when an enterprise or an individual technological complex is transferred to power supply from an autonomous power plant with a capacity comparable to that of the electrical consumers. The article presents the results of a comparative analysis of substation configurations, in which technical solutions for ensuring EMC of power sources and electrical equipment of technological complexes have been applied.