Oct 2026· Optics Express· Vol 34 21, pp.
39674-39685
· 0 citations
Medicine
Abstract
Millimeter-wave photonic links increasingly demand photodetectors with frequency responses tailored to specific operating bands. Conventional modified uni-traveling carrier photodiodes (MUTC-PDs) exhibit low-pass frequency responses, and maintaining a flat in-band response becomes increasingly challenging as the operating band approaches the intrinsic device bandwidth. Here, we demonstrate a waveguide MUTC-PD integrated with an on-chip stub-line matching network for band-selective response shaping. Baseline devices with active areas of 4 × 10, 5 × 10, and 5×12 μm2 were fabricated and characterized. The 4×10 μm2 device exhibited a 3-dB bandwidth of 104 GHz, and all device sizes showed an external responsivity of approximately 0.4 A/W. A 5×10 μm2 active area was then used for the stub-line-integrated devices to improve fabrication tolerance. The integrated matching network introduces a resonant peak that compensates the RC roll-off and forms a flat passband. For a fixed photodiode geometry and electrode configuration, the passband center frequency is mainly adjusted by the stub-line length. An 80-µm-stub device achieved a measured in-band flatness within ±1 dB from 75 to 110 GHz. A 60-µm-stub device shifted the response toward the F-band; its measured response agreed with the circuit model up to the 110-GHz instrumentation limit, and the model predicted comparable flatness over the intended F-band range. These results indicate that stub-line-integrated MUTC-PDs can provide band-tailored responses for millimeter-wave photonic links.
We demonstrate a weakly resonant cavity-enhanced modified uni-traveling-carrier photodiode (MUTC-PD) incorporating distributed Bragg reflectors (DBRs), enabling enhanced optical absorption through controlled weak resonance while preserving wide bandwidth to overcome the responsivity-bandwidth trade-off in high-speed ph...
Scaling of artificial intelligence data centers is pushing the aggregate speed of photonic transceivers over 1.6 Tb/s and even 3.2 Tb/s, which in the multi-channel configuration accounts for a 200 Gb/s data transmission speed for each wavelength. Uni-traveling carrier photodetectors have proved high bandwidth performan...
Han Ye, Qin Han, Li-Yan Geng et al.· Photonics· 0 citations
Microwave photonic (MWP) filters are key devices for microwave systems because of their low loss, high bandwidth, and electromagnetic interference immunity. Sharp roll-off is important for accurate spectral filtering and effective suppression of interference. However, electronic MWP filters struggle to simultaneously a...
Yang Sun, Jia-Yang Wu, Yang Li et al.· Photonic Computing: From Mat...· 0 citations
Millimeter-wave and terahertz technologies offer new opportunities for high-capacity communications, sensing, and quantum systems, but electronic signal chains above 100 GHz are limited by weak sources, noisy receivers, and lossy interconnects. Photonic approaches mitigate these constraints by enabling chip-scale high-...
Jia-Wen Liu, Cheng-Li Wang, A. Gaier et al.· 1 citation
The terahertz (THz) frequency range provides a wide bandwidth for future high-capacity wireless links. However, compact THz sources that combine high conversion efficiency, flat frequency response, and multiband adaptability remain a major challenge. We propose a unified architecture of a photomixer module for multiban...
Yin-Jun Liu, B. Xiong, Jun-Wen Zhang et al.· Advanced Photonics Nexus· 0 citations
We use cookies to run the site and, with your consent, for analytics and to show ads.
See our Cookie Policy.