Skip to content

Na-Layer K+ Pillaring with CeO2 Coating Enables High-Rate and Air-Stable P2-Type NaMn-Layered Oxide Cathodes.

Nov 2026 · ACS Applied Materials and Interfaces · 0 citations · 58 references
Medicine

Abstract

P2-type NaxMnO2 cathodes offer high capacity and elemental abundance, yet their practical application is limited by the Jahn-Teller distortion of Mn3+ and irreversible phase transitions that drive structural degradation, capacity fading, and air sensitivity. Prevailing strategies rely predominantly on element substitution at transition-metal sites, whether via single or dual doping, or in combination with coating, but inevitably impose a capacity-stability trade-off rooted in the alteration of the TM-O framework. Here, we demonstrate a synergistic strategy to construct a high-rate, air-stable P2-Na0.62K0.05MnO2/CeO2 cathode, by combining K+ bulk doping at Na sites with a CeO2 surface coating. The K+ bulk doping mitigates the Jahn-Teller effect, eliminates the low-voltage P2-P'2 transition, and converts the high-voltage P2-OP4 transition into a solid-solution reaction, while the CeO2 overlayer concurrently provides resistance to ambient air. The optimized Na0.62K0.05MnO2/CeO2 cathode delivers 67.95 mAh g-1 at 10C, retains 84.00% of its capacity after 200 cycles at 1C and 71.03% after 500 cycles at 5C, and preserves structural integrity after air exposure and water immersion. This dual-modification approach establishes Na-site doping as a design principle that decouples structural stabilization from transition-metal redox activity in P2-type oxide cathodes.

View source

Similar papers

Sep 2026

Synergistic Al/Ti Co-doping and MgO Surface Engineering of O3-Type NaNi0.5Mn0.5O2 Cathodes for High-Performance Sodium-Ion Batteries

O3-type NaNi0.5Mn0.5O2 is considered a promising cathode material for sodium-ion batteries, but its electrochemical performance is limited by rapid capacity fading associated with Jahn–Teller distortion of Mn3+ and irreversible O3–P3 phase transitions at high voltages. To address these issues, a combined strategy inv...

Jia-Xuan He, Zi-Han Ma, Yu Duan et al. · 0 citations
Nov 2026

Mitigating P2 - P2' phase transition and lattice oxygen loss toward high-performance Fe/Mn-based Na-ion layered cathodes.

P2-type Fe/Mn-based layered oxides are a compelling low-cost, high-capacity cathode for sodium-ion batteries (NIBs). However, the structural stability and electrochemical performance are severely constrained by Jahn-Teller-induced phase transitions and lattice oxygen loss at high voltage. Herein, a high-valence Sb5+-su...

Xiao-Hui Lin, Yi-Da Xu, Zhen Li et al. · 0 citations
Oct 2026

Riveting Rubidium in Alkali-Metal Layers: High-Performance P2-Type Layered Oxide Cathodes for Potassium-Ion Batteries.

Layered manganese-based oxides for potassium-ion batteries (PIBs) suffer from severe structural degradation, primarily due to irreversible phase transitions, Jahn-Teller distortion, and sluggish K+ diffusion kinetics. Here, we propose an alkali-metal site riveting strategy by selectively incorporating oversized Rb+ ion...

Li-Peng Duan, Yi-Chen Du, Qi-Xiang Huang et al. · 0 citations
Open access Oct 2026

Antisite-Driven Self-Pillaring as a Design Strategy for High-Voltage P2-Type Na-Ion Cathodes: Zr-Doped P2-Na0.84Zr x Ni0.37– x Mn0.63O2

Sodium-ion batteries are very promising for sustainable large-scale energy storage. Among various cathode materials, Mn-based P2-type layered oxides emerged for their high theoretical capacity and fast sodium-ion diffusion pathways, but the detrimental P2-O2 phase transition at high voltage limits their cycle life an...

Andrea Grillo, A. Massaro, A. Muñoz-García et al. · 0 citations
Open access Oct 2026

Gradient Mg and Uniform Ti Co-Doping Suppresses Jahn-Teller Effect in LMFP via Optimized Ion-Transport Kinetics and Interfacial Reactions.

LiMn0.6Fe0.4PO4 (LMFP), an olivine-type cathode material, is gaining attention in high-energy-density lithium-ion batteries due to its high operating voltage and cost-effectiveness. However, its practical use is limited by slow Li+ diffusion, poor electronic conductivity, and structural degradation caused by Jahn-Telle...

Ji-Xue Shen, Gao-Qiang Mao, Qing-Chao Zeng et al. · 0 citations
Oct 2026

Tunnel/P2 Interlocking Structure Coupled with TiO2 Interface Modification for Synergistically Enhanced Structural Stability of Sodium-Ion Battery Cathodes

Layered Mn-based oxides are promising cathode materials for sodium-ion batteries, which are prone to an irreversible P2-O2 phase transition during cycling and thus exhibit poor cyclic stability. Although tunnel-type Mn-based oxides feature a stable structure, they deliver a low sodium storage capacity. In this work,...

Yu Duan, Jia-Xuan He, Shuo Bao et al. · 0 citations

We use cookies to run the site and, with your consent, for analytics and to show ads. See our Cookie Policy.