Skip to content
Open access

Advanced Modeling, Design, and Performance Characterization of a PIN Photodiode

Sep 2026 · Asian Journal of Electrical and Electronic Engineering · 0 citations · 4 references

Abstract

InGaAs PIN photodiodes are essential components for detecting near-infrared (NIR) light, particularly valued for their ability to function effectively at room temperature in areas such as fiber-optic communications and advanced imaging systems. This study focuses on the design, simulation, and performance analysis of an In₀.₅₃Ga₀.₄₇As PIN photodiode, followed by a comparison with a fabricated prototype. Simulation results indicate that lowering the absorber-layer doping concentration from 1×10¹⁶ to 1×10¹⁵ cm⁻³ slightly improves peak quantum efficiency (QE), increasing from approximately 56.8% to 57.9%. Meanwhile, a slightly higher doping level can help reduce the dark current density. A device incorporating a lightly doped (quasi-intrinsic) InGaAs absorber layer with a doping concentration close to 1×10¹⁵ cm⁻³ was grown on an InP substrate. Capacitance–voltage (C–V) measurements confirmed a doping concentration of about 1.2×10¹⁵ cm⁻³, with the device displaying capacitance in the low picofarad range under reverse bias. The resulting 130 µm-diameter photodiode exhibited a measured dark current density of approximately 10⁻⁴ A/cm² at a reverse bias of −1.5 V, compared with a simulated total dark current density of approximately 7×10⁻⁷ A/cm² at the same bias. The measured value is substantially higher than the simulated bulk contribution, consistent with additional perimeter-related leakage mechanisms not captured by the bulk generation–recombination model. The measured value is substantially higher than the simulated bulk contribution, consistent with additional perimeter-related leakage mechanisms not captured by the bulk generation–recombination model. Thermal analysis revealed an activation energy of roughly 0.34 eV, indicating that the dark current is primarily influenced by generation–recombination processes and leakage through shunt paths at ambient temperatures. The photodiode showed a peak quantum efficiency of about 54.7% at 1.4 µm without antireflection (AR) treatment, which improved significantly to around 80% with an optimized AR coating. These findings highlight the importance of carefully tuning the absorber doping level because lighter doping widens the depletion region, lowering junction capacitance and raising QE simultaneously. At the same time, the larger generation volume comes at the cost of higher dark current. Lighter doping widens the depletion region, lowering junction capacitance and raising QE, but the larger generation volume increases dark current. Overall, the study emphasizes the role of doping control and surface passivation in enhancing the performance of high-efficiency NIR PIN photodiodes.

Read PDF

We use cookies to run the site and, with your consent, for analytics and to show ads. See our Cookie Policy.