Skip to content
Open access

SMA-Based Actuation for Soft Robotic Grippers in Space Applications

Dec 2026 · IEEE Robotics and Automation Letters · Vol 11, pp. 14620-14627 · 0 citations · 36 references

Abstract

Soft robotic grippers offer adaptable, debris-agnostic capture of non-cooperative space objects, but conventional actuators impose substantial mass, power, and qualification constraints. This work investigates Shape Memory Alloy (SMA) tendons as lightweight actuators for soft grippers in vacuum, exploiting reduced convective heat losses to accelerate heating and lower energy consumption, despite slower cooling. A 1 U CubeSat-conformal gripper, fabricated from low-outgassing silicone and actuated by spring-shaped NiTi SMA tendons, was experimentally tested in the PISCES vacuum chamber at TU Delft. Two actuator configurations were evaluated, using 1 mm and 2 mm wires with transition temperatures of 40°C and 60°C, respectively. Vacuum operation reduced actuation time by up to 77% under zero load and increased actuator force, while fingertip contact force was measured directly. For a four-finger configuration, closure energy decreased from 311 J in ambient conditions to 70 J in vacuum, indicating potential savings in onboard energy storage. Subsequent thermal-vacuum cycling at ESA ESTEC revealed that simulated sunlight raised SMA temperatures to 60–65°C, producing approximately 50% unintended actuation. Mechanical pretension (9.7 N in the tested case) mitigated this effect at the expense of available grasping force. The silicone gripper remained structurally stable, although slight crystallization was observed at low temperature. These findings support SMA-driven capture in vacuum while identifying thermal management as a critical design requirement. Future work will explore embedded phase-change materials and microgravity capture experiments using air-bearing platforms.

Read PDF

We use cookies to run the site and, with your consent, for analytics and to show ads. See our Cookie Policy.