Oct 2026· Scientific Reports· Vol 16· 0 citations· 45 references
Abstract
Temperature and in-situ stress both affect the properties of formation rocks. Marble and sandstone were heat treated and the changes in their composition were analysed by X-ray diffraction (XRD). A thermal-mechanical-damage (TMD) model was established to characterise the thermal damage before impact. Dynamic compression tests under active confining pressure were carried out in a split Hopkinson pressure bar (SHPB), and the fracture surfaces were examined by scanning electron microscopy (SEM). Thermal damage in marble appears as external tensile and internal shear failure, whereas sandstone shows mainly internal tensile failure. Without confining pressure, the dynamic peak stress of marble decreases with temperature, while that of sandstone first increases and then decreases. Under confining pressure the dynamic peak stress of marble increases with temperature up to 600 °C and drops sharply at 800 °C, while for sandstone the temperature of maximum dynamic peak stress rises with the confining pressure, from 200 °C at 2 MPa to 600 °C at 6 MPa; both rocks are strongest at 600 °C and 6 MPa. Under confinement, marble treated at 400–600 °C mostly separates along fracture surfaces after impact, whereas sandstone cracks far less at its strongest temperature than at room temperature.
High-temperature-induced thermal damage in rocks critically affects the long-term stability of surrounding rock masses. Understanding the mechanical responses and damage evolution mechanisms of rocks under elevated temperatures is essential for safety assessment and risk mitigation in deep high-temperature rock enginee...
Hui Zhou, Zi Li, Nan Jiang et al.· Fractal and Fractional· 0 citations
Seepage from water-rich strata and persistent roof water inflow during coal mining can substantially weaken the mechanical properties of coal and rock masses. Elevated in situ stress and geothermal temperature in deep roadways further accelerate deterioration and increase the risk of engineering instability. In this st...
Tao Luo, Jiao-Tao Xu, Shi-Zhong Zhang et al.· ACS Omega· 0 citations
The thermomechanical behavior of the Ti-6Al-4V (Ti64) alloy under hot deformation is determined by a complex interplay between strain hardening and thermally assisted restoration processes that finally lead to the formation of the resultant microstructure and mechanical properties. In this research, the effects of defo...
Thermal shock serves as a potential stimulation method for hot dry rock (HDR); however, the mechanisms through which it induces reservoir damage and improves permeability remain to be thoroughly investigated. To address this issue, laboratory mechanical tests under gradient thermal shock temperatures ranging from 300...
Qi Niu, Yun-Tian Wu, Zi-Jian Zhang et al.· Journal of Petroleum Geology· 0 citations