Skip to content
Open access

Y-Source-Based Half-Bridge Inverters: A Method to Attain Elevated Boost Factors With Reduced Power Stresses

2026 · IEEE Access · Vol 14, pp. 167788-167804 · 0 citations · 31 references

Abstract

Half-bridge-based Z-source inverters have recently gained attention due to their advantageous properties, particularly their ability to generate a neutral voltage level at the output stage. However, achieving high boost factors while maintaining low voltage and current stresses and a reasonable number of components remains challenging. This paper introduces two generalized families of coupled-inductor-based half-bridge inverters, from which four distinct topologies can be derived. The proposed configurations provide elevated boost factors while maintaining relatively low voltage and current stresses on the power devices. A comprehensive comparison with existing half-bridge-based impedance-source inverters is conducted in terms of boost factor, component count, voltage and current stresses, and the proposed components’ power ratio (CPR). The comparative results demonstrate that the proposed topologies achieve particularly favorable diode and switch voltage ratings, as well as low-to-moderate device currents, especially for a coupled-inductor turns-ratio parameter of (K= 2). Furthermore, the proposed concept is experimentally validated using a prototype with a 20 V input voltage. With a shoot-through duty ratio of 0.4, a boost factor of 5 is obtained, resulting in an experimentally measured output voltage of approximately 100 V. The measured maximum blocking voltages of the diodes and switches are approximately 100 V and 200 V, respectively, in close agreement with the theoretical predictions. These results confirm the effectiveness of the proposed topologies in achieving high voltage gain with reduced power-device stresses.

Read PDF

We use cookies to run the site and, with your consent, for analytics and to show ads. See our Cookie Policy.