Skip to content
Conference Open access

Experimental Investigation and Taguchi-Based Parameter Optimization of FDM-Printed Carbon-Fiber-Reinforced PLA for Bush-Bearing Applications

2026 · EPJ Web of Conferences · 0 citations · 13 references

Abstract

FDM provides a tool-less option for the production of lightweight polymer parts; however, the anisotropic nature and process-related flaws of such parts restrict their use in tribological and load-bearing applications. In this study, CF-PLA is evaluated for the bushing type application using a Taguchi L9 orthogonal array analysis coupled with an independent pin-on-disc wear test. The controllable parameters selected for FDM process include raster angle, infill and printing temperatures that are varied at three levels, namely, 0°, 45° and 90°; 50%, 75% and 100%; and 200, 210 and 220 °C, respectively. The collected impact strength response is evaluated with respect to the larger-is-better signal to noise ratio characteristics. It was found that raster angle dominates among the main effects, while the optimal combination is A3B2C2 corresponding to 90° raster angle, 75% infill and 210 °C. The measured Charpy and Izod impact energy values are 23.465 and 9.130 J, respectively. Specific wear rates calculated from the corrected pin-on-disc experiment ranged from 3.007 × 10 −7 to 5.413 × 10 −6 mm 3 /(N•m).

Read PDF

We use cookies to run the site and, with your consent, for analytics and to show ads. See our Cookie Policy.