Oct 2026· Electronics· Vol 15, pp. 4508· 0 citations· 15 references
TL;DR
The main contribution is a five-stage differential current-starved ring VCO using gate-to-body-connected dynamic-threshold MOS devices and sleep-stack transistors placed only in alternate stages to limit the added delay and capacitive loading.
Abstract
This paper presents transistor-level building blocks for fractional-N frequency synthesis in 45 nm CMOS. The main contribution is a five-stage differential current-starved ring VCO using gate-to-body-connected dynamic-threshold MOS devices and sleep-stack transistors placed only in alternate stages to limit the added delay and capacitive loading. The digital section includes an eight-stage multi-modulus frequency divider based on push-pull cascode logic divide-by-2/3 cells and a MASH 1-1-1 sigma-delta controller. All circuits are implemented in Cadence Virtuoso with a nominal 1.0 V supply. Post-layout simulation of the VCO gives an oscillation frequency of 9.24 GHz, phase noise of −124.38 dBc/Hz at a 1 MHz offset, and power consumption of 59.4 µW, corresponding to an FoM of −215.96 dBc/Hz. At Vctrl=0.5 V, the extracted VCO remains oscillatory over 60 combined process, supply voltage, and temperature conditions, with the oscillation frequency ranging from 6.43 to 10.96 GHz. The MMFD, MASH controller, and their integrated fractional-division path are evaluated under the reported nominal operating conditions; PVT robustness of the combined digital path is not established in this work. The digital-path validation includes analysis of fractional-divider command convergence, edge-count consistency, output line spectra, and characterization of the third-order noise-transfer response. The work focuses on the design and validation of individual frequency-synthesis building blocks rather than a complete closed-loop fractional-N PLL.
This work presents the first dual-modulus 2/3 true-single-phase-clock (TSPC) frequency divider implemented in 22nm FDSOI CMOS technology operating up to 58GHz. The presented divider maintains robust divide-by-2 and divide-by-3 operation over an input frequency range from 8GHz to 58GHz. The design exploits wide-range bo...
T. Baluta, Yerzhan Kudabay, V. Issakov· European Microwave Integrate...· 0 citations
The contribution of this paper is a single, coordinated threshold-voltage reduction method for sub-1 V bulk-FinFET mm-Wave front-ends, in which three levers fin-count sizing, a shared substrate-tie body-bias bus, and transformer-coupled under-neutralization are applied to the low-noise amplifier, the down-conversion mi...
T. Tamilselvi, A. Rahuman· Journal of Circuits, Systems...· 0 citations
This paper presents a Ka-band two-stage differential CMOS power amplifier (PA) in 65-nm CMOS for 5G millimeter-wave applications (26.5–29.5 GHz). The anti-phase IMD3 cancellation method, originally developed for sub-GHz two-stage PAs, exploits opposite signs of the large-signal third-order transconductance (G<inline-fo...
Sunju Kim, Changkun Park· IEEE Access· 0 citations
This work presents the design, implementation, and characterization of a single-core ultra-wideband (UWB) 5-bit flash ADC, utilizing an innovative back-gate-based reference voltage generation, and an inherent on-chip static offset calibration scheme. To the authors’ best knowledge, the reported work represents the fast...
Nima Lotfi, P. Scholz, F. Gerfers· European Microwave Integrate...· 0 citations
This article presents a low-jitter and wideband hybrid injection-locked multiphase clock generator (HIL-MPCG) featuring a frequency-tracking-loop (FTL)-controlled HIL scheme and a voltage-mismatch-cancellation (VMC) technique. The proposed FTL-controlled HIL scheme switches from multiphase injection to two-phase inject...
Hong-Zhi Wu, Xu-Xu Cheng, Yang-Yi Zhang et al.· IEEE transactions on microwa...· 0 citations
We use cookies to run the site and, with your consent, for analytics and to show ads.
See our Cookie Policy.