Measurement-Based Evaluation of Lane-Keeping Assist System Response Under Suspension Geometry Misalignment

Abstract

Lane-Keeping Assist Systems (LKAS) are widely used in modern passenger vehicles to support lateral vehicle control and reduce the risk of unintended lane departure. Although LKAS performance is commonly evaluated in relation to perception, control, and sensor fusion, the observable vehicle response may also depend on the mechanical condition of the chassis. This study presents a qualitative, measurement-based evaluation of the influence of intentionally introduced front-wheel toe misalignment on the observable response of a production LKAS under controlled proving-ground conditions. Experimental tests were conducted on the highway module of the ZalaZONE proving ground using a Lexus RX 450h equipped with a factory-installed LKAS function. Three front-wheel toe configurations were investigated: factory-specified alignment, single-wheel toe misalignment, and severe toe misalignment affecting both front wheels. Measurements were performed at 70, 90, and 110 km/h on straight and curved road sections. Vehicle speed, steering angle, lateral acceleration, and GNSS-based position data were recorded using CAN- and GNSS/IMU-based data acquisition. The qualitative comparison of the measured signal profiles indicated that the misaligned configurations were associated with a shifted steering-angle operating range and less uniform steering and lateral-acceleration responses. The most pronounced visible differences occurred under the severe toe-misalignment condition, particularly at higher speeds and in the curved section. As the analysis did not include quantitative effect measures or statistical comparisons, these observations are interpreted as exploratory tendencies rather than statistically validated changes in LKAS performance. The findings suggest that front-wheel toe condition should be considered in the measurement-based assessment, maintenance, and calibration of ADAS-equipped vehicles.