Sep 2026· 2026 Energy Conversion Congress & Expo Europe (ECCE Europe)· pp. 1-6· 0 citations· 16 references
Abstract
Current Source Inverters (CSIs) offer several unique advantages, such as sinusoidal output voltage and inherent short-circuit protection for high-performance drive applications. However, CSIs using Silicon (Si) IGBTs are constrained by their switching frequencies, necessitating bulky DC-link inductors. Although the Silicon Carbide (SiC) devices can operate at high frequencies, the CSI topology still suffers from the need for lossy series diode based reverse-blocking (RB) switches and sensitivity to commutation overlap. This paper provides a comprehensive analysis comparing the traditional reverse-blocking CSI configuration (H6-RB-CSI), which incorporates series Schottky diodes, with a modified H7-dual-gate bidirectional switch based CSI (H7-BD-CSI). Additionally, the study examines the effect of varying overlap times on the CSI output fundamental current. Simulations were conducted using a three-phase RL-load to evaluate the performance of both inverter topologies. The results demonstrate that the H7-BD-CSI topology significantly reduces conduction losses, and the output fundamental current exhibits minimal sensitivity to circuit protection time.
The Z-source inverter (ZSI) has emerged as an effective single-stage power conversion topology for renewable energy applications owing to its inherent capability to perform both voltage buck and boost operations. However, the shoot-through states required for voltage boosting introduce additional harmonic distortion th...
Tusetso Rethabile Johannes, M. Kabeya, M. Ngongoma· Energies· 0 citations
The Z-source inverter(ZSI) has emerged as a promising power electronic interface for energy conversion systems due to its inherent voltage boost capability and reduced conventional inverter topologies. In addition to the wide range of ZSI topological variants, modulation and control strategies play a decisive role in d...
Asma Behlouli, E. Berkouk, Mohand Oulhadj Mahmoudi et al.· Engineering Research Express· 0 citations
The rapid penetration of photovoltaic, wind, and hybrid distributed energy resources requires compact power-electronic interfaces capable of high efficiency, low harmonic distortion, and reliable grid synchronization. This paper develops a methodology for a high-efficiency nine-level asymmetrical cascaded H-bridge (ACH...
Haruto Voronova· International Journal of Adv...· 0 citations
This article analyzes dead-time effects in the full-bridge inverter topology with constant common-mode voltage (FB-CCV) for transformerless grid-connected photovoltaic (PV) applications and proposes a modulation strategy to mitigate the resulting output-voltage distortions, common-mode transients, and power losses. Alt...
Arnaldo O. Cunha, Filipe A. da C. Bahia, J. P. R. A. Méllo et al.· IEEE Open Journal of the Ind...· 0 citations
The integrated gate-commutated thyristor (IGCT) devices, as widely utilized power semiconductors in hard-switching high-power applications, necessitate an external clamp circuit to limit current slew rate during turn-ON events. While the design and operating principles of the clamp circuit are exhaustively investigated...
Amin Darvishzadeh, D. Dujić· 2026 IEEE 22nd International...· 0 citations
The Active-Clamped Forward-Flyback is a topology suitable for photovoltaic applications, since it offers high efficiency across wide input/output voltage and power ranges, zero-voltage switching (ZVS) on all the switches and zero-current switching (ZCS) on the secondary side devices, while allowing high power density d...
J. Perez-Martinez, Juan Cruz-Cozar, Cristina Martos-Contreras et al.· IEEE Open Journal of Power E...· 0 citations
We use cookies to run the site and, with your consent, for analytics and to show ads.
See our Cookie Policy.