Oct 2026· Engineering Research Express· Vol 8, pp. 205306· 0 citations· 33 references
Physics
Abstract
The capability of boosting voltage and converting it into alternating current simultaneously and in a single stage is a characteristic of Z-source-based inverters, which makes them attractive. This feature increases system reliability as well as simplifies its design. In this paper, a new single-stage five-level inverter based on a quasi-impedance network is presented. The meaning of single-stage is that in the proposed topology, the voltage boosting feature as well as inverter operation are performed in one stage. In the proposed topology, the voltage stress on the capacitors is reduced. In addition, efforts have been made to reduce the number of passive elements in the structure. In the proposed structure, the input current is continuous, which is one of its important features. A comparison has also been made between this converter and the existing quasi-Z-source-based converters in terms of the number of power electronic devices, as well as the number of passive components, and so on. This shows the advantages of the proposed structure. The operating principles of the proposed topology and the effectiveness of the modulation method in steady-state and transient operation are investigated through simulation in MATLAB software and then verified by the results obtained from the experimental prototype.
We provide a new seventeen-level cross-connected T-type (CT-type) inverter with a lower device count (RDC) in this study. Just eight power switches, four self-balancing capacitors, and two DC sources are needed for the suggested design. It reduces the voltage stress on the switches by avoiding the need for an H-bridge...
Dhananjay Kumar, Vishal Rathore, Santosh Kumar Gupta et al.· Suranaree Journal of Science...· 0 citations
Half-bridge-based Z-source inverters have recently gained attention due to their advantageous properties, particularly their ability to generate a neutral voltage level at the output stage. However, achieving high boost factors while maintaining low voltage and current stresses and a reasonable number of components rem...
M. Aalami, Ebrahim Babaei, M. Sabahi· IEEE Access· 0 citations
This research proposes two enhanced single-stage quasi-Z-source AC-AC converters. Both topologies have non-inverted output that utilizes pulse width modulation (PWM) and are founded on a boost AC-AC chopper. Further, the converters' ability to maintain a common ground between the input and output is a significant advan...
F. Sedaghati, Saeed Padban, Reza Mohajery et al.· Scientific Reports· 0 citations
To address the issues of high component count, complex control, and large volume associated with conventional multilevel inverters in residential photovoltaic (PV) energy storage systems, a novel 11-level voltage-multiplier inverter topology is proposed in this paper. The proposed structure consists of a front-end volt...
Shi Liu, Cheng-Jun Liu, Gao-Yue Guo et al.· 2026 IEEE 9th Information Te...· 0 citations
This article proposes a single-source common-ground 13-level switched-capacitor boost inverter featuring reduced voltage stress and improved reliability. It can boost the output voltage up to sixfold and can work satisfactorily under a wider range of modulation indices with self-balancing of the capacitors’ voltage. It...
Devanand Kumar, Ravi Raushan, Prashant Kumar et al.· IEEE Journal of Emerging and...· 0 citations
The integration of solar photovoltaic systems into the grid presents itself with several novel issues that need to be solved before successful integration can be achieved. The problem of common-mode current, also known as leakage current, is one such concern when a trans-formerless system is preferred due to the benefi...
Dilip Kumar Arya, Mohammed Asim, Monauwer Alam et al.· Sigma Journal of Engineering...· 0 citations
We use cookies to run the site and, with your consent, for analytics and to show ads.
See our Cookie Policy.