Skip to content
Open access

Mechanical, Computational, and Biological Evaluation of 3D-Printed PLA-Bioactive Glass Scaffolds for Bone Tissue Regeneration

Sep 2026 · Materials · Vol 19 · 0 citations · 57 references
Medicine

TL;DR

Findings demonstrate the synergistic effect of BG incorporation and surface modification in enhancing the performance of FDM-printed PLA scaffolds, supporting their potential use in bone tissue engineering.

Abstract

Additive manufacturing enables the production of patient-specific biodegradable scaffolds for tissue regeneration. Polylactic acid (PLA), an FDA-approved polymer widely used in tissue engineering, suffers from hydrophobicity that limits cell adhesion, slows degradation, and may trigger inflammatory responses. To address these limitations, PLA was combined with bioactive glass (BG) particles to obtain printable composite filaments. Four BG compositions (45S5, S53P4, 45S5_MS, and S53P4_MS) were evaluated to determine whether Mg- and Sr-doped formulations improve biological performance of composites. The composites were characterized from morphological, physical, and mechanical standpoints, while scaffold wettability was further enhanced through alkaline surface treatment prior to in vitro cytocompatibility assays. BG incorporation increased brittleness and reduced compressive strength, while tensile properties remained comparable to pure PLA. Alkaline treatment effectively improved hydrophilicity and promoted cell adhesion and proliferation. Fluorescence microscopy revealed that scaffolds containing doped BG compositions supported particularly dense and well-spread cell populations. These findings demonstrate the synergistic effect of BG incorporation and surface modification in enhancing the performance of FDM-printed PLA scaffolds, supporting their potential use in bone tissue engineering.

Read PDF

Similar papers

Open access Sep 2026

Electrospun PCL/BG composite scaffolds: processing, optimization and surface modification to improve wettability and cell attachment.

This study focused on optimizing previously developed procedures for producing electrospun PCL/BG scaffolds, with particular attention to overcoming the intrinsically hydrophobic nature of electrospun PCL, which may limit scaffold functionality.

Francesco Gerardo Mecca, D. Bellucci, Alessia Mazzilli et al. · 0 citations
Open access Oct 2026

3D-Printed Polycaprolactone/Alginate-Whitlockite Composite Scaffolds for Bioactive Bone Tissue Engineering

Despite advances in 3D printing, achieving simultaneous mechanical stability and biological functionality in polymer-based scaffolds remains challenging for bone tissue engineering applications. In this study, 3D-printed scaffolds fabricated from a polycaprolactone/alginate (PCL/Alg) composite reinforced with different...

Sura Ali Al-Nidawi, A. Najafinezhad, H. Abbastabar Ahangar et al. · 0 citations
Open access Aug 2026

Photocrosslinked PEG-PVP-Pullulan Composites Reinforced With Brushite: A Preliminary Bone-Facing Material for Osteochondral Tissue Engineering

Objectives: The development of biomaterials for bone tissue engineering requires a combination of suitable mechanical properties, bioactivity, and cytocompatibility. In this study, photocrosslinked polymer-ceramic composites based on poly(vinylpyrrolidone) (PVP), poly(ethylene glycol) (PEG), and pullulan were developed...

Karina Niziołek, Dagmara Słota, Katarzyna Haraźna et al. · 0 citations

We use cookies to run the site and, with your consent, for analytics and to show ads. See our Cookie Policy.