Sep 2026· Journal of Instrumentation· Vol 21, pp. P09012· 0 citations· 23 references
Physics
TL;DR
A measured assessment of the practical benefits and limitations of in-pixel front-end amplification for low-noise and high-dynamic-range (HDR)-oriented CMOS image sensors is provided.
Abstract
Front-end amplification inside a pixel can reduce the contribution of downstream readout noise in complementary metal-oxide-semiconductor (CMOS) image sensors, but its practical value must be assessed together with penalties in spatial uniformity, implementation overhead, and operating complexity. This work presents a CMOS image sensor prototype incorporating an in-pixel operational transconductance amplifier (OTA) with switchable unity-gain and open-loop high-gain modes. A dedicated transfer-gate layout optimization is also implemented to reduce the floating-diffusion capacitance and improve the conversion gain. The prototype enables a same-chip comparison between the proposed OTA pixel and a reference four-transistor (4T) pixel under a common readout environment. Measurement results show that the in-pixel OTA can reduce the input-referred temporal noise (down to 0.67 e - rms) by suppressing the contribution of subsequent readout stages, while the high-gain mode also increases pixel-to-pixel variation and spatial non-uniformity. A measured pixel conversion gain of up to 6.47 mV/ e - is achieved in the open-loop high-gain mode. The switchable-gain operation supports wide-dynamic-range readout by combining low-gain and high-gain responses. In addition to temporal-noise characterization, image lag and spatial non-uniformity are evaluated, and the results are discussed in terms of the trade-off between noise reduction, uniformity, and implementation cost. This work therefore provides a measured assessment of the practical benefits and limitations of in-pixel front-end amplification for low-noise and high-dynamic-range (HDR)-oriented CMOS image sensors.
CMOS high-speed optical receivers (ORXs) feature low power, low cost, and high integration density. However, the design of ORXs in scaled CMOS technology is challenging due to the reduced intrinsic gain and voltage supply. This paper starts by briefly describing conventional full-bandwidth (FBW) receivers that cascade...
Diaaeldin Abdelrahman, G. Cowan, M. Atef· IEEE Circuits and Systems Ma...· 0 citations
To address the susceptibility of single-photon avalanche diodes (SPADs) to false triggering under strong background illumination and the lack of flexibility in traditional macro-pixel readout architectures, this paper proposes an FPGA-based adaptive and reconfigurable macro-pixel SPAD array readout circuit. The design...
Yi-Ling Zeng, Fei Yuan, Na Tian et al.· IEEE Photonics Journal· 0 citations
Future electron–positron colliders require vertex detectors with high spatial resolution, low noise, and stringent power constraints. The compact pixel for vertex (CPV-4) prototype combines a pinned depleted diode (PDD) sensor with a silicon-on-insulator (SOI) analog front-end, whose performance is jointly determined b...
Wei-Da Zheng, Yun-Peng Lu, Yang Zhou et al.· IEEE Transactions on Nuclear...· 0 citations
MWIR and LWIR applications exhibit elevated signal amplitudes that severely constrain available dynamic range and risk driving the analog pixel into saturation. Conversely, the Digital Pixel Sensor (DPS) enables the integration of in-pixel continuous-time oversampling Analog-to-Digital Conversion (ADC), offering the ul...
Martin Lapeyre, P. Martin-Gonthier, O. Saint-Pé et al.· Optical Engineering + Applic...· 0 citations
This article presents a 28-nm CMOS 1-chip LED-on-Silicon (LEDoS) backplane (BP) for 6652-pixel-per-inch (PPI) microLED augmented reality (AR) displays and introduces four display quality enhancement methods: MSB data shuffling, 2-bit bias calibration and tuning, dead-pixel compensation, and spatial/temporal dithering.
Sunkwon Kim, Y. Kwon, Youngkil Choi et al.· IEEE Journal of Solid-State...· 0 citations
This article presents CPRE64-CZT, a low-noise 64-channel front-end readout application-specific integrated circuit (ASIC) for cadmium zinc telluride (CdZnTe or CZT) detector systems that require configurable-polarity cathode and anode readout. Each channel integrates a low-noise charge-sensitive amplifier (CSA), a high...
Hao-Long Liao, Ke Wang, Nan-Kun Wang et al.· IEEE Transactions on Nuclear...· 0 citations
We use cookies to run the site and, with your consent, for analytics and to show ads.
See our Cookie Policy.